SUNY CANTON COLLEGE
ELECTRICAL ENGINEERING TECHNOLOGY

ELEC141 Industrial Controls
hartle@canton.edu

Reading Assignment:

Lab Report Assignment: Due __3/19/20xx______

• Overhead Door Simulation Lab.  Read The ProSim-II Door Simulation file:///C:/LOGIXPRO%20NO%20CD%20REQUIRED!/doc/dl/dl-rl.html
• Complete Student Programing Excercises 1, 2, and 3.  Programs to meet all requirements as stated and effective use of both instruction and rung comments to clearly document your program. 
• Include an address assignment table in the report.
• Design Excercise 2 in two different methods.  One to be coil interlock design (must push stop before direction change), and the second design to be pushbutton interlock design (can change direction by just pushing the opposite direction button).
• Submit a print of the four programs, address assignment table, Input and Output Connection Diagrams, and cover page at the beginning of class on 3/18/2014.

Classroom objectives:

• 10 Min Quiz
• Logix Pro PLC Simulator (brought to you by The Learning Pit dot com) http://thelearningpit.com/
• The LogixPro PLC Simulator Offline Training Resource Page C:/LOGIXPRO%20NO%20CD%20REQUIRED!/doc/index.html
• Getting started with PLC's http://thelearningpit.com/plc/plcs.html
• How to Install the AB SLC® Instruction Set Reference Manual .... Link!
• DOCUMENTATION, labeling rungs and instructions.
  

Laboratory excercises:

• Silo Simulation to get you started. When you have LogixPro running select the Silo Simulation, then click Load in the File Menu and select
  the file "silo.rsl". Once it is loaded and you can see it, you can then "DownLoad" it to the PLC. At this point you can place the PLC into the
  "RUN" mode. If all goes well, just clicking on the simulations START pushbutton should get the whole process going
• LogixPro Door Simulation Lab Utilizing Relay Logic